Відео

"This bud's for you" Dilettantes !

Thanks! I was starting to look online about buying a replacement receiver. But your video’s guide to clearing/resetting brought my unit back to life and saved me a hundy and a couple hours of time

One other thing I'll add for people who complain about these saws leaking. There is an authorized DeWalt and Milwaukee repair center in my town, the technician said the saws are designed to leak oil on the chain to lubricate it, they really don't have a pump like a big two-cycle chainsaw does. Best practice is to drain the oil tank when you're done sawing. I use 30 wt air compressor oil for bar oil it leaks but lubricates the chain and bar well.

Your video really helped me, I busted off my chain break handle I needed to replace it. 1 trick I learned after redoing my repair cuz I forgot to put the rubber boot on the chain brake handle. Do Not mess with that Big spring you don't need to take it out. First remove that little arc shaded spring that raps 180° around the chain brake handle, then engage chain break by pushing handle forward, then pull the pin and remove chain brake handle. Reverse the steps to reassemble. Your video was really good very detailed thank you.

does this trimmer hread work with the FS70R?

One day I needed to reboot one of these, I had to disconnect the neutral or hot wire for 5 seconds just to do that lol

what is that rumbling sound in the beginning?

I have a dudley lock at home I forgot the numbers to. I will try this to see if it works!

yup, it is a booger manually removing and then reinstalling the tire.

Thank you, this was very helpful

Keurig was not but a month old. One of the K pods did not puncture and so it filled the needles up with coffee grounds, thus causing it to shut off to prevent overflow. Use a paper clip to dislodge coffee grounds. Take out inner basket to poke with paper clip and rinse. I just poked the top white tip as much as I could ran a clean clear cup of water and BAM!! Coffee grounds flowed out.

bullshit explanation

i really wanna see if this product also resets the outlet for you with that power button that says "push to reset" as my gfci outlet in my backyard does not have a reset button. I'm wondering if this device does that for me.

I wonder if it’s possible to swap the Car2u unit with a home link from a 2014 or newer?

I replaced the power supply board and it’s still doing the same thing. Any guesses??

It worked thanks🫡

Thanks man, I honestly forgot how to do it since the last time I strung mine up and who really keeps the instructions? I had completely forgot about lining the arrows and line up, that's what bit me.

Where did you get that wood with seal? And if you DIY what is the material list?

Cant do it

Dude... I love your video! It showed me how to do this without getting highly frustrated. If I didn't see some of your tips and tricks, I certainly would be a mess!

My lights don’t light up even ! I got this from a neighbor who said you can have it if you’re up for the challenge and know any hacks . I tried your ideas and still no light up. Have any other ideas for me ? I have a single serve keurig but wanted an upgrade . Do you know why my cup sizes don’t light up ? No water will come out. It makes a sound and then stops.

I hope the engineer who moved the battery here has been fired!!!!!

Great video! My pool was built with pentair products in 2022. Last night I noticed one light was out and one was flickering! I'm waiting to hear back from the pool builder.

Thank you. I just bought the same brand. Great video & service. Can you recommend heavy duty wires and diff types.

What size are the nuts?

Software reset immediately fixed my issue where only the front speakers were putting out music. Thank you dor your video, sony's website was not helpful in the slighest

Thank you so much. My fiancée has an identical one like this. We couldn't reset it. Now we have a new code. Thanks again and God bless you.

Thanks man! I have done plenty of tires, but the smaller front ZTR wheels are a pita! The second set of pliers and using one spoon was the trick.

Thanks for the video I have a 2013 Tahoe that I bought used with 96 thousand miles on it the doo handle was bad then it a lot worse now two years later will definitely try this for a fix thanks

Thanks man, this worked like a dream

Man I have been thinking what to fix that with for a while. Simple solution is usually the best thanks

Nightmare is about right.

Where did you purchase the seat cover?

I’m a warranty center for pentair after corona the globrites started having problems. I believe I was told there was record of 59,000 globrites out. An that was just people under warranty. So from the corona through to the first week of 2024 was basically all problem lights that was installed. Been to a lot of pools the first week after start up they were failing. An had to be replaced. All were leaks that caused it. After the 1st week of 2024 was when the newer version came out that addressed the issues it was having. So if you purchase from anywhere Amazon maybe or eBay. Make sure you look for that blue oring on the light. That indicates it’s a newer one that was after the problem lights. Or if you know the date prior to purchase. I mean you can get one with an older date. But be prepared of a high likelihood of replacing it from failing. Pentair just has gotten caught up in the last few months of replacing out all of them bad lights. I have a couple boxes full of old lights I cut off of the cords that I personally done. But even if you get one an it last a few months. Still isn’t great. It’s still gigh probability of it failing. An globrite only has a 1 year warranty unlike the microbrite that has a 2 year warranty. I was actually instructed for some people to use the retrofit niche kit and replace out all of some peoples globrite for microbrite during corona. Due to microbrite not having had the same issues. The only time the globrites have longer than a 1 year warranty is if you just had your pool built. An have other Pentair items. If one buys 3 major Pentair items. Everything is blanketed under a three-year warranty. Regardless of how many lights pumps ect ect. But if you just buy a single light or a few lights it’s only a year. My advice is to stay away from any older lights that was in that bad period though. It’s just not worth the trouble. I e put in a lot of the improved ones since the beginning of the year. An as of now. I’ve only had 1 fail. Vs during the peak of virus time. I may of put 2-3 at one pool an within a month they had atleast one out. If not more. So avoid em to Davy yaself headache, and hassle

Thanks for sharing the video I had found a lock and was figuring out what the code was and came across your video and must say it opened like baam thank you again ❤❤

Nice video. Question: why there's no water coming out after you removed the lid? Thanks

I really like this tester.. being able to remove it and see the results is what makes it the best in my opinion 👍👍

What is that black filter used for?

this is 💯 worked..thanks..😉

Hello, Are you interested in testing our products? We would like to invite you to test the Full Windshield for your Kawasaki Mule SX (if your car year is 2017+

It’s worked!! I had to be patient and wriggle the check valve and ring 5 or 6 times after each time I ran the cycles before it released the blockage. Yay!

would it make sense to just fill the sediment filter with hydrogen peroxide run the water to fill the tank?

Awh, thanks. That little gray button fell out and I couldn’t figure out where it went. Problem solved!

Thanks!

Thank you I flooded my four wheeler and all it needed was a oil change

Worked like a charm!! Thank you!!!

It’s easier just to go to your breaker box and knock down the breakers for a few minutes. Less climbing around. Just a suggestion.

This helped me so much!

Thank you very much! This fixed my keurig!

Great advice !😊